Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Cadillac >> 2010 >> STS 3.6 V, AWD >> Repair and Diagnosis >> Engine Performance >> Engine Control Systems >> Engine Controls And Fuel - 3.6L - Repair Instructions >> Repair Instructions >> Knock Sensor Replacement - Bank 1 >> Removal Procedure

Removal Procedure

    Fig 1: Knock Sensor Electrical Connector
    GM945742Courtesy of GENERAL MOTORS CORP.
  1. Turn the ignition OFF.
  2. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
  3. Reposition the wiring harness heat shield to obtain access.
  4. Remove the knock sensor (KS) electrical connector.
    5. Fig 2: Knock Sensor & Bolt
    GM860801Courtesy of GENERAL MOTORS CORP.
  5. Remove the KS bolt.
  6. Remove the KS.
scientia non olet · About Mike's Workshop Manuals