Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Cadillac >> 2010 >> Escalade EXT >> Repair and Diagnosis >> Engine Performance >> System >> Engine Control System & Fuel System - 5.3L, 6.0L, 6.2L - DTC P0300 To P1175 >> DTC P0641 or P06A6 >> Circuit/System Testing

Circuit/System Testing

  1. Ignition OFF, disconnect harness connector of the B47 fuel pressure sensor.
  2. Ignition OFF, test for less than 1.0 Ω between the low reference circuit terminal 2 and ground.
    • If greater than the specified range, test the low reference circuit for an open/high resistance. If the circuit tests normal, replace the K27 fuel pump control module.
  3. Ignition ON, test for 4.8-5.2 V between the 5 V reference circuit terminal 3 and ground.
    • If less than the specified range, test the 5 V reference circuit for a short to ground or an open/high resistance. If the circuit tests normal, replace the K27 fuel pump control module.
    • If greater than the specified range, test the 5 V reference circuit for a short to voltage. If the circuit tests normal, replace the K27 fuel pump control module.
  4. If all circuits test normal, replace the B47 fuel pressure sensor.
scientia non olet · About Mike's Workshop Manuals