Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Cadillac >> 2010 >> Escalade EXT >> Repair and Diagnosis >> Engine Performance >> Engine Control Systems >> Engine Control System & Fuel System - 5.3L, 6.0L, 6.2L - Repair Instructions >> Repair Instructions >> Evaporative Emission System Cleaning >> Inspection Procedure

Inspection Procedure

IMPORTANT: Do not perform this procedure unless instructed by an evaporative emission (EVAP) diagnostic.
  1. Turn OFF the ignition.
  2. Remove the EVAP canister purge solenoid valve. Refer to Evaporative Emission Canister Purge Solenoid Valve Replacement .
  3. Lightly tap the EVAP canister purge solenoid valve on a clean hard surface.
  4. Inspect for carbon particles exiting either of the vacuum ports.
    • If no carbon particles are found reinstall the EVAP canister purge solenoid valve and continue with the EVAP cleaning procedure. Refer to Evaporative Emission Canister Purge Solenoid Valve Replacement .
    • If carbon particles are found during the inspection procedure, replace the EVAP canister purge solenoid valve and continue with the EVAP cleaning procedure. Refer to Evaporative Emission Canister Purge Solenoid Valve Replacement .
    • If you were instructed to replace the EVAP canister purge solenoid valve, and no carbon particles are found, return to the EVAP diagnostic procedure. Do not perform the EVAP cleaning procedure.
scientia non olet · About Mike's Workshop Manuals