Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Cadillac >> 2010 >> DTS 4.6 9 >> Repair and Diagnosis >> Engine Performance >> System >> Engine Control System & Fuel System - 4.6L - DTC P0351 To P2271 >> DTC P2271 >> Circuit/System Verification

Circuit/System Verification

  1. Ignition ON, observe the DTC information with a scan tool. Verify that no HO2S heater DTCs are set.
  2. Engine idling, move the appropriate HO2S 2 harness connector and the engine control module (ECM) harness connector while monitoring the HO2S 2 voltage parameter with a scan tool. Verify that the HO2S parameter does not change abruptly while moving the related harnesses.
    • If the HO2S parameter does change abruptly while moving the related harnesses repair the circuit as necessary.
  3. Engine idling at operating temperature, observe the appropriate HO2S 2 parameter with a scan tool. The HO2S 2 value should change greater than 200 mV when the throttle is quickly cycled 3 times from closed to wide open and back to closed after running the engine at 1,500 RPM for 30 seconds.
  4. Operate the vehicle within the Conditions for Running the DTC to verify the DTC does not reset. You may also operate the vehicle within the conditions that you observed from the Freeze Frame/Failure Records data.
scientia non olet · About Mike's Workshop Manuals