Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Cadillac >> 2010 >> CTS V, Standard >> Repair and Diagnosis >> Brakes >> Antilock Brake System With Traction Control System & Stability Control System >> Diagnostic Information and Procedures >> DTC C0035-C0050 >> Circuit/System Testing

Circuit/System Testing

  1. Ignition OFF, disconnect the harness connector at the EBCM.
  2. Ignition ON, test for less than 1 V between the ignition voltage circuit terminal of the appropriate sensor listed below and ground.
    • Left front sensor circuit terminal 29
    • Right front sensor circuit terminal 6
    • Left rear sensor circuit terminal 5
    • Right rear sensor circuit terminal 2
    • If greater than the specified range, test the ignition voltage circuit for a short to voltage.
  3. Test for less than 1 V between the signal circuit terminal of the appropriate sensor listed below and ground.
    • Left front sensor circuit terminal 28
    • Right front sensor circuit terminal 17
    • Left rear sensor circuit terminal 4
    • Right rear sensor circuit terminal 3
    • If greater than the specified range, test the signal circuit for a short to voltage.
  4. Ignition OFF, test for infinite resistance between the ignition voltage circuit terminal of the appropriate sensor circuit listed below and ground.
    • Left front sensor circuit terminal 29
    • Right front sensor circuit terminal 6
    • Left rear sensor circuit terminal 5
    • Right rear sensor circuit terminal 2
    • If less than the specified value, test the ignition voltage circuit for a short to ground.
  5. Test for infinite resistance between the following signal circuit terminal of the appropriate sensor circuit listed below and ground.
    • Left front sensor circuit terminal 28
    • Right front sensor circuit terminal 17
    • Left rear sensor circuit terminal 4
    • Right rear sensor circuit terminal 3
    • If less than the specified value, test the signal circuit for a short to ground.
  6. Ignition OFF, disconnect the harness connector at the appropriate wheel speed sensor.
  7. Test for less than 2 Ω between the appropriate ignition voltage circuit terminals listed below.
    • Left front sensor circuit terminal 29 at the EBCM harness connector and terminal 1 at the wheel speed sensor harness connector.
    • Right front sensor circuit terminal 6 at the EBCM harness connector and terminal 1 at the wheel speed sensor harness connector.
    • Left rear sensor circuit terminal 5 at the EBCM harness connector and terminal 1 at the wheel speed sensor harness connector.
    • Right rear sensor circuit terminal 2 at the EBCM harness connector and terminal 1 at the wheel speed sensor harness connector.
    • If greater than the specified range, test the ignition voltage circuit for an open or high resistance.
  8. Test for less than 2 Ω between the appropriate signal circuit terminals listed below.
    • Left front sensor circuit terminal 28 at the EBCM harness connector and terminal 2 at the wheel speed sensor harness connector.
    • Right front sensor circuit terminal 17 at the EBCM harness connector and terminal 2 at the wheel speed sensor harness connector.
    • Left rear sensor circuit terminal 4 at the EBCM harness connector and terminal 2 at the wheel speed sensor harness connector.
    • Right rear sensor circuit terminal 3 at the EBCM harness connector and terminal 2 at the wheel speed sensor harness connector.
    • If greater than the specified range, test the signal circuit for an open or high resistance.
  9. If all circuits test normal, replace the appropriate wheel speed sensor. If the DTC resets, replace the EBCM.
scientia non olet · About Mike's Workshop Manuals