Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Cadillac >> 2009 >> XLR Base >> Repair and Diagnosis >> Steering >> Steering Wheel & Steering Column >> Repair Instructions >> Steering Column Replacement >> Installation Procedure

Installation Procedure

    Fig 1: Locking Steering Column
    GM333146Courtesy of GENERAL MOTORS CORP.
  1. With the aid of an assistant, install the steering column.
  2. Install the 2 of the steering column mounting bolts.
  3. Install the pinch bolt for the intermediate shaft to steering column. Finger tighten the bolt only.
    4. Fig 2: Identifying Steering Column Mounting Bolts
    GM1551471Courtesy of GENERAL MOTORS CORP.
    CAUTION: Refer to Fastener Caution .
  4. Install the reminding steering column bolts and tighten in sequence to 24 N.m (18 lb ft).
  5. Tighten the pinch bolt to specifications to 48 N.m (35 lb ft).
  6. Install the tilt motor and bracket assembly. Refer to Tilt Actuator Assembly Replacement .
  7. Install the telescoping motor. Refer to Telescope Actuator Assembly Replacement .
  8. Reconnect the steering column electrical connectors.
  9. Install the heater duct.
    10. Fig 3: Identifying Closeout Shroud, Lower Steering Column Trim Cover & Retaining Screws
    GM588300Courtesy of GENERAL MOTORS CORP.
  10. Install the lower steering column shroud. Refer to Steering Column Trim Covers Replacement .
    11. Fig 4: View Of Knee Bolster & Bolts
    GM348714Courtesy of GENERAL MOTORS CORP.
  11. Install the knee bolster panel. Refer to Driver Knee Bolster Bracket Replacement .
  12. Remove the J 42640  .
  13. Reconnect the battery. Refer to Battery Negative Cable Disconnection and Connection .
  14. Enable the SIR system. Refer to SIR Disabling and Enabling .
scientia non olet · About Mike's Workshop Manuals