Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Cadillac >> 2009 >> XLR Base >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Engine Controls And Fuel - 4.4L - Introduction, Specifications & Repair Instructions) >> Repair Instructions >> Crankshaft Position Sensor Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: View Of Crankshaft Position Sensor & Bolt
    GM928205Courtesy of GENERAL MOTORS CORP.
    NOTE: Inspect the crankshaft sensor O-ring for wear or damage. If a problem is found, replace the O-ring.
  1. Lubricate the crankshaft sensor O-ring with clean engine oil.
    2. CAUTION: Refer to Fastener Caution .
  2. Install the crankshaft sensor and the retaining bolt and tighten to 10 N.m (89 lb in).
  3. Connect the crankshaft position sensor electrical connector.
  4. Install the supercharger. Refer to Supercharger Replacement .
  5. Perform the crankshaft position sensor system variation learn procedure. Refer to Crankshaft Position System Variation Learn .
scientia non olet · About Mike's Workshop Manuals