Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Cadillac >> 2009 >> XLR Base >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Engine Controls And Fuel - 4.4L - Introduction, Specifications & Repair Instructions) >> Repair Instructions >> Accelerator Pedal Position Sensor Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Identifying Accelerator Pedal & Bolts
    GM931700Courtesy of GENERAL MOTORS CORP.
  1. Install the accelerator pedal to the steering column support bracket.
    2. CAUTION: Refer to Fastener Caution .
    NOTE: Always use a torque wrench in order to obtain the proper torque.
  2. Install the accelerator pedal mounting bolts (1) and tighten to 10 N.m (89 lb in).
    3. Fig 2: Identifying Accelerator Pedal Sensor Module Electrical Connector
    GM1252542Courtesy of GENERAL MOTORS CORP.
  3. Connect the accelerator pedal sensor module electrical connector (1).
  4. Check for correct carpet fit under the accelerator pedal.
  5. Install the left I/P on the lower closeout insulator panel. Refer to Instrument Panel Insulator Panel Replacement - Left Side .
scientia non olet · About Mike's Workshop Manuals