Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Cadillac >> 2009 >> XLR Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 29 (Engine Control System & Fuel System - 4.6L (LH2) - Introduction) >> Repair Instructions >> Accelerator Pedal Position Sensor Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2008 Cadillac SRX. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Identifying Accelerator Pedal
    GM910941Courtesy of GENERAL MOTORS CORP.
  1. Position the accelerator pedal (1) to the vehicle.
    2. NOTE: Refer to Fastener Notice .
  2. Install the accelerator pedal bolts (2).

    Tighten:  Tighten the bolts to 5 N.m (44 lb in).

  3. Connect APP sensor electrical connector.
  4. Install the left I/P sound insulator. Refer to Instrument Panel Insulator Panel Replacement - Left Side (Left Hand Drive) or Instrument Panel Insulator Panel Replacement - Left Side (Right Hand Drive) .
scientia non olet · About Mike's Workshop Manuals