Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Cadillac >> 2009 >> XLR Base >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls And Fuel - 4.6L (LH2) - Introduction, Specifications & Repair Instructions >> Repair Instructions >> Filler Tube Replacement >> Installation Procedure

Installation Procedure

    Fig 1: View Of Fuel Filler Pocket & Fuel Tank Fill & Vent Pipe
    GM71231Courtesy of GENERAL MOTORS CORP.
    CAUTION: Refer to Fastener Caution .
  1. Install the fuel tank fill and vent pipe to the fuel filler pocket and tighten to 3.5 N.m (31 lb in).
    2. Fig 2: View Of Fuel System Ground Strap
    GM43530Courtesy of GENERAL MOTORS CORP.
  2. Connect the fuel fill pipe ground strap. Tighten the fuel fill pipe ground strap bolt to 4.0 N.m (35 lb in).
    3. Fig 3: Identifying Fuel Fill Hose & Vent Hose
    GM562230Courtesy of GENERAL MOTORS CORP.
  3. Uncap the openings on the fuel fill hose (1) and the vent hose (2).
  4. Connect the fuel fill hose (1) and the vent hose (2) to the fuel tank fill and vent pipe and tighten the fuel fill hose clamp to 3.5 N.m (31 lb in).
  5. Install the left rear wheelhouse liner panel. Refer to Rear Wheelhouse Panel Liner Replacement .
  6. Install the fuel filler cap.
scientia non olet · About Mike's Workshop Manuals