Mass Airflow Sensor/Intake Air Temperature Sensor Replacement

WARNING: This page is about a different variant/trim than selected.

Fig 1: Identifying MAF Screws, Seal & Sensor

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
Preliminary Procedures Turn OFF the ignition. Remove the air cleaner duct. Refer to Air Cleaner Inlet Duct Replacement .
1	Screw (Qty: 2) CAUTION: Refer to Fastener Caution . Tighten: 3.25 N.m (29 lb in)
2	Mass Airflow Sensor/Intake Tempature Sensor Procedure: Disconnect the sensor wiring harness.
3	Gasket