Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Cadillac >> 2009 >> STS V >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 4 (Engine Controls And Fuel - 3.6L - Introduction) >> Repair Instructions >> Engine Coolant Temperature Sensor Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: View Of ECT Sensor
    GM1285193Courtesy of GENERAL MOTORS CORP.
    CAUTION: Refer to Fastener Caution .
  1. Install the coolant temperature sensor and tighten to 22 N.m (16 lb ft).
  2. Install the coolant temperature sensor electrical connector.
    3. Fig 2: View Of Electrical Connector Heat Protector
    GM1997115Courtesy of GENERAL MOTORS CORP.
  3. Slide the electrical connector heat protector (1) onto the electrical connector.
  4. Inspect and fill the cooling system as necessary. Refer to Cooling System Draining and Filling (GE 47716) or Cooling System Draining and Filling (Static Fill) .
scientia non olet · About Mike's Workshop Manuals