Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Cadillac >> 2009 >> STS V >> Repair and Diagnosis >> Accessories & Equipment >> Collision/Avoidance >> Object Detection System >> Diagnostic Information and Procedures >> Lane Departure Warning System Malfunction >> Circuit/System Testing

Circuit/System Testing

IMPORTANT: Before disconnecting the harness connector at the VDAAW module, ensure that the ignition has been OFF for at least 120 seconds. Failure to do so may result in component damage.
  1. Ignition OFF for 120 seconds, disconnect the harness connector at the VDAAW module.
  2. Ignition OFF, test for less than 1.0 ohm between the ground circuit terminal 4 and ground.
    • If greater than the specified range, test the ground circuit for an open/high resistance.
  3. Ignition ON, verify a test lamp illuminates between the B+ circuit terminal 2 and ground.
    • If the test lamp does not illuminate, test the B+ circuit for a short to ground or an open/high resistance.
  4. If all circuits test normal, replace the VDAAW module.
scientia non olet · About Mike's Workshop Manuals