Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Cadillac >> 2009 >> STS Base, 4.6 A, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 249 (Engine Controls And Fuel - 3.6L - Repair Instructions) >> Repair Instructions >> Knock Sensor Replacement - Bank 2 >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2010 Cadillac STS. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Knock Sensor & Bolt
    GM860802Courtesy of GENERAL MOTORS CORP.
  1. Install the KS.
    2. CAUTION: Refer to Fastener Caution .
  2. Install the KS bolt and tighten to 23 N.m (17 lb ft).
    3. Fig 2: Knock Sensor Electrical Connector
    GM945380Courtesy of GENERAL MOTORS CORP.
  3. Install the KS electrical connector.
  4. Install the wiring harness heat shield to the oil level indicator tube.
  5. Lower the vehicle.
scientia non olet · About Mike's Workshop Manuals