Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Cadillac >> 2009 >> STS Base, 4.6 A, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 249 (Engine Controls And Fuel - 3.6L - Repair Instructions) >> Repair Instructions >> Knock Sensor Replacement - Bank 1 >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2010 Cadillac STS. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Knock Sensor & Bolt
    GM860801Courtesy of GENERAL MOTORS CORP.
  1. Install the KS.
    2. CAUTION: Refer to Fastener Caution .
  2. Install the KS bolt and tighten to 23 N.m (17 lb ft).
    3. Fig 2: Knock Sensor Electrical Connector
    GM945742Courtesy of GENERAL MOTORS CORP.
  3. Install the KS electrical connector.
  4. Install the wiring harness heat shield to the original position.
  5. Lower the vehicle.
scientia non olet · About Mike's Workshop Manuals