Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Cadillac >> 2009 >> STS Base, 4.6 A, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 249 (Engine Controls And Fuel - 3.6L - Repair Instructions) >> Repair Instructions >> Crankshaft Position Sensor Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2010 Cadillac STS. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Crankshaft Position Sensor & Bolt
    GM1311144Courtesy of GENERAL MOTORS CORP.
  1. Install the crankshaft position sensor.
    2. CAUTION: Refer to Fastener Caution .
  2. Install the crankshaft position sensor bolt and tighten to 10 N.m (89 lb in).
    3. Fig 2: CKP Electrical Connector
    GM887868Courtesy of GENERAL MOTORS CORP.
  3. Connect the CKP electrical connector (3).
    4. Fig 3: Exhaust Manifold Heat Shield
    GM945964Courtesy of GENERAL MOTORS CORP.
  4. Install the exhaust manifold heat shield and tighten to 10 N.m (89 lb in).
  5. Lower the vehicle.
scientia non olet · About Mike's Workshop Manuals