Installation Procedure

WARNING: This page is about a different variant/trim than selected.

Fig 1: Identifying Crankshaft Position (CKP) Sensor

Courtesy of GENERAL MOTORS CORP.

CAUTION: Refer to Fastener Caution .

Install the crankshaft position sensor bolt.
Tighten: Tighten the crankshaft position sensor bolt to 10 N.m (89 lb in).

Fig 2: Locating CKP Electrical Connector

Courtesy of GENERAL MOTORS CORP.

Fig 3: View Of Right Exhaust Manifold Heat Shield

Courtesy of GENERAL MOTORS CORP.

Install the exhaust manifold heat shield.
Tighten: Tighten the bolts to 10 N.m (89 lb in).
Lower the vehicle.