Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Cadillac >> 2009 >> SRX 3.6 7, AWD >> Repair and Diagnosis >> Engine Performance >> System >> Engine Control System & Fuel System - 3.6L - Introduction >> Repair Instructions >> Camshaft Position Sensor Replacement - Bank 1 (Right Side) Intake >> Installation Procedure

Installation Procedure

    Fig 1: View Of Right CMP Sensor - Intake
    GM1285251Courtesy of GENERAL MOTORS CORP.
  1. Install the CMP sensor.
    2. CAUTION: Refer to Fastener Caution .
  2. Install the CMP sensor bolt.

    Tighten:  Tighten the CMP sensor bolt to 10 N.m (89 lb in).

    3. Fig 2: View Of Right CMP Sensor Electrical Connector - Intake
    GM1285245Courtesy of GENERAL MOTORS CORP.
  3. Install the CMP sensor electrical connector.
  4. Install the ECM bracket with the ECM. Refer to Engine Control Module Replacement .
  5. Install the power steering fluid reservoir. Refer to Remote Power Steering Fluid Reservoir Replacement (LH2) or Remote Power Steering Fluid Reservoir Replacement (LY7) .
scientia non olet · About Mike's Workshop Manuals