Installation Procedure

NOTE: All threads must be clean prior to LOCTITE® application. Check the LOCTITE®, or equivalent, container for the expiration date. Use only enough LOCTITE® to evenly coat the threads.

Apply LOCTITE® 262, or equivalent, to the steering gear inner tie rod threads.
Attach the steering linkage inner tie rod onto the steering gear rack.

Fig 1: View Of Inner Tie Rod Housing & Rack

Courtesy of GENERAL MOTORS CORP.

Place a pipe wrench on the flats on the steering gear rack (1) next to the steering linkage inner tie rod (2).

CAUTION: Refer to Fastener Caution .

Tighten the steering linkage inner tie rod (2).
Tighten: Tighten the steering linkage inner tie rod to 150 N.m (111 lb ft).
Install the steering gear boot. Refer to Steering Gear Boot Replacement .