Automatic Level Control Description and Operation: Notes
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2007 GMC Yukon XL, 2007 GMC Yukon, 2007 Chevrolet Tahoe, 2007 Chevrolet Suburban, and 2007 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
The automatic level control (ALC) system maintains a desired rear suspension position under all types of towing, hauling and loading conditions. The following components are involved in the operation of the ALC system:
- Air line tubing-Pressurized air from the ALC compressor is pumped to each of the rear shocks via air line tubing.
- Air drier-Pressurized air from the compressor is run through a drier containing a moisture absorbing chemical preventing water accumulation in the rear shocks.
- Compressor-Supplies pressurized air to the rear shocks
- Compressor motor relay-The relay supplies battery positive voltage to the ALC compressor motor.
- Pressure sensor-The electronic suspension control module (ESCM) module provides a 5-volt reference and low reference to the ALC pressure sensor. The module receives the signal voltage that is relative to the air pressure applied to the rear shocks.
- ESCM-Controls the ALC system and electronic suspension control (ESC) system and detects failures in both. The module monitors inputs from the position sensors, and pressure sensor to determine when to raise and lower the vehicle to trim height as the vehicle is loaded or unloaded. The module limits pump activation to 255 seconds to prevent thermal damage.
- Exhaust valve-An electric solenoid activated by the ESCM to vent air pressure from the rear shocks.
- Left and right rear suspension position sensors-The module provides a 5-volt reference and low reference to all 4 of the body-to-wheel suspension position sensors. The sensors send the ESCM a signal voltage that is relative to the rear suspension ride height
- Left and right rear shock absorbers with internal air chambers and dampers-Dampens the rear suspension and maintains trim height depending on the air pressure applied.