Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Cadillac >> 2009 >> Escalade EXT >> Repair and Diagnosis >> External Pages >> Different car >> Section 260 (Engine Control System & Fuel System - 5.3L, 6.0L, 6.2L - Repair Instructions) >> Repair Instructions >> Fuel Pressure Sensor Replacement >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2010 GMC Yukon XL, 2010 GMC Yukon, 2010 Chevrolet Tahoe, 2010 Chevrolet Suburban, and 2010 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Fuel Pressure Sensor
    GM1911651Courtesy of GENERAL MOTORS CORP.
  1. Lubricate a NEW fuel pressure sensor O-ring seal with clean engine oil.
  2. Install the NEW fuel pressure sensor O-ring seal (2) onto the fuel line fitting.
  3. Wrap a shop towel around the fuel pressure sensor fitting in order to absorb any fuel that may leak out.
    4. CAUTION: Refer to Fastener Caution .
  4. Install the fuel pressure sensor (1) to the fuel line.

    Tighten:  Tighten the sensor to 15 N.m (11 lb ft).

    5. Fig 2: Locating Chassis Wiring Harness Electrical Connector
    GM1911650Courtesy of GENERAL MOTORS CORP.
  5. Connect the chassis wiring harness electrical connector (1) to the fuel pressure sensor.
  6. Lower the vehicle.
  7. Use the following procedure in order to inspect for leaks:
    1. Turn the ignition ON, with the engine OFF, for 2 seconds.
    2. Turn the ignition OFF for 10 seconds.
    3. Turn the ignition ON, with the engine OFF.
    4. Inspect for fuel leaks.
scientia non olet · About Mike's Workshop Manuals