Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Cadillac >> 2009 >> Escalade EXT >> Repair and Diagnosis >> External Pages >> Different car >> Section 250 (Battery, Charging System And Starting System) >> Repair Instructions >> Battery Positive Cable Replacement (without TP2) >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2010 GMC Yukon XL, 2010 GMC Yukon, 2010 Chevrolet Tahoe, 2010 Chevrolet Suburban, and 2010 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Battery Positive Cable Nut
    GM2352375Courtesy of GENERAL MOTORS CORP.
    CAUTION: Refer to Fastener Caution .
  1. Install the battery positive cable to the battery fuse block with nut (1) and tighten to 10 N.m (88 lb in)
    2. Fig 2: Battery Positive Cable Retainers
    GM2352376Courtesy of GENERAL MOTORS CORP.
  2. Install the battery positive cable retainers (1) to the upper plenum.Install the battery positive cable clip nuts (1) to the studs on the upper plenum.
    3. Fig 3: Underhood Fuse Block Cover, Retainers & Battery Positive Connector
    GM2338469Courtesy of GENERAL MOTORS CORP.
  3. Install the battery positive cable connector (3) to the underhood fuse block.
  4. Ensure that the underhood fuse block retainers (2) are in the open position.
  5. Position and engage the junction block to the 4 bracket pivots, push the retainers (2) down into the locked position.
  6. Install the underhood fuse block cover.
  7. Connect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection .
scientia non olet · About Mike's Workshop Manuals