Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Cadillac >> 2009 >> Escalade EXT >> Repair and Diagnosis >> External Pages >> Different car >> Section 232 (Wiper System & Washer System) >> Repair Instructions >> Windshield Washer Solvent Container Replacement >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2010 GMC Yukon XL, 2010 GMC Yukon, 2010 Chevrolet Tahoe, 2010 Chevrolet Suburban, and 2010 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Washer Solvent Container & Screws
    GM1669972Courtesy of GENERAL MOTORS CORP.
  1. Transfer washer pumps and level indicator to the new washer solvent container.
    2. Fig 2: View Of Wheelhouse & Windshield Washer Solvent Container Assembly
    GM1733024Courtesy of GENERAL MOTORS CORP.
  2. Install the windshield washer container assembly.
  3. Install the upper windshield washer container bolt to the auxiliary battery tray, if equipped.
    4. CAUTION: Refer to Fastener Caution .
  4. Install the upper windshield washer solvent container bolts and tighten to 9 N.m (80 lb in).
  5. Install the auxiliary battery tray, if equipped. Refer to Battery Tray Replacement .
  6. Install the windshield washer solvent cap.
  7. Connect the electrical connectors.
    8. Fig 3: Locating Washer Pump Hoses
    GM1733021Courtesy of GENERAL MOTORS CORP.
  8. Connect the washer pump hoses (1, 2). Refer to Windshield Washer Hose Replacement .
  9. Install the left front wheelhouse liner. Refer to Front Wheelhouse Liner Replacement - Left Side .
  10. Install the left front wheel assembly. Refer to Tire and Wheel Removal and Installation .
  11. Fill the washer solvent container with windshield solvent. Refer to Fluid and Lubricant Recommendations (USA and Canada) .
scientia non olet · About Mike's Workshop Manuals