Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Cadillac >> 2009 >> CTS Base, 3.6 7, AWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Engine Controls And Fuel - 6.2L - Introduction) >> Repair Instructions >> Accelerator Pedal Position Sensor Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Locating APP Sensor
    GM1407620Courtesy of GENERAL MOTORS CORP.
  1. Install the APP sensor to the front of dash.
    2. CAUTION: Refer to Fastener Caution .
  2. Install the APP sensor mounting nuts and tighten to 9 N.m (80 lb in).
  3. Connect the APP sensor electrical connector.
  4. Operate the accelerator pedal and observe the APP angles using a scan tool. The accelerator pedal should operate freely, without binding between closed throttle and wide open throttle.
  5. Install the closeout/insulator panel. Refer to Instrument Panel Insulator Replacement - Left Side (Left Hand Drive) or Instrument Panel Insulator Replacement - Left Side (Right Hand Drive) or Instrument Panel Insulator Replacement - Right Side (Left Hand Drive) or Instrument Panel Insulator Replacement - Right Side (Right Hand Drive) .
scientia non olet · About Mike's Workshop Manuals