Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Cadillac >> 2009 >> CTS Base, 3.6 7, AWD >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls And Fuel - 3.6L - Introduction >> Repair Instructions >> Knock Sensor Replacement - Bank 2 >> Removal Procedure

Removal Procedure

    Fig 1: View Of Left Knock Sensor & Electrical Connector
    GM945380Courtesy of GENERAL MOTORS CORP.
  1. Turn the ignition OFF.
  2. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
  3. Remove the wiring harness heat shield from the oil level indicator tube to gain access.
  4. Remove the knock sensor (KS) electrical connector.
    5. Fig 2: View Of Left Knock Sensor
    GM860802Courtesy of GENERAL MOTORS CORP.
  5. Remove the KS bolt.
  6. Remove the KS.
scientia non olet · About Mike's Workshop Manuals