Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Cadillac >> 2008 >> XLR Base >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Engine Controls And Fuel - 4.4L - Introduction) >> Repair Instructions >> Knock Sensor 2 Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: View Of Knock Sensors & Electrical Connectors
    GM1284306Courtesy of GENERAL MOTORS CORP.
  1. Remove the supercharger assembly. Refer to Supercharger Replacement .
  2. Disconnect the electrical connector (2) from the knock sensor (KS) (1).
  3. Remove the bolt in the center of the KS.
  4. Remove the KS (1) from the engine block.
scientia non olet · About Mike's Workshop Manuals