Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Cadillac >> 2008 >> XLR Base >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Engine Controls And Fuel - 4.4L - Introduction) >> Repair Instructions >> Fuel Level Sensor Replacement - Left Side >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: View Of Fuel Pump Module
    GM1767507Courtesy of GENERAL MOTORS CORP.
  1. Remove the left fuel tank module (2). Refer to Fuel Tank Fuel Pump Module Replacement - Left Side .
  2. Remove the fuel pump module O-ring (3) from the fuel tank opening.
    3. Fig 2: Identifying Fuel Level Sensor
    GM1767514Courtesy of GENERAL MOTORS CORP.
  3. Press down on the locking tab and remove the level sensor (1) from the module.
  4. Make a note of the wire location in relation to the internal connector.
  5. Remove the level sensor wires from the internal connector. Refer to Delphi Connectors (Weather Pack) or Delphi Connectors (Push To Seat) or Delphi Connectors (Pull To Seat) or Delphi Connectors (Micro-Pack 100W) or Delphi Connectors (Micro .64) or Delphi Connectors (12-Way) .
scientia non olet · About Mike's Workshop Manuals