Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Cadillac >> 2008 >> XLR Base >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Engine Controls And Fuel - 4.4L - Introduction) >> Repair Instructions >> Barometric Pressure Sensor Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Identifying BARO, MAP & SCIAP Sensors
    GM1613998Courtesy of GENERAL MOTORS CORP.
  1. Install the BARO sensor (2) to the bracket.
  2. Connect the BARO sensor electrical connector.
  3. Install the engine sight shield. Refer to Intake Manifold Sight Shield Replacement .
scientia non olet · About Mike's Workshop Manuals