Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Cadillac >> 2008 >> STS Base, 3.6 V, AWD >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls And Fuel - 3.6L - Introduction (2 Of 2) >> Repair Instructions >> Mass Airflow Sensor/Intake Air Temperature Sensor Replacement >> Removal Procedure

Removal Procedure

    Fig 1: View Of Air Cleaner Assembly
    GM1201221Courtesy of GENERAL MOTOR CORP.
  1. Remove the air cleaner inlet duct. Refer to Air Cleaner Inlet Duct Replacement .
  2. Disconnect the engine wiring harness electrical connector (1) from the mass air flow (MAF) sensor (2).
    3. Fig 2: Removing/Installing MAF Screws, Seal & Sensor
    GM1958368Courtesy of GENERAL MOTORS CORP.
  3. Remove the MAF sensor screws (1).
  4. Remove the MAF sensor (2).
  5. Remove and discard the MAF sensor seal (3).
scientia non olet · About Mike's Workshop Manuals