Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Cadillac >> 2008 >> SRX 3.6 7, AWD >> Repair and Diagnosis >> Engine Performance >> System >> Engine Control System & Fuel System - 3.6L - DTC P0341 To DTC P2099 >> DTC P0650 >> Circuit/System Testing

Circuit/System Testing

  1. If any other IPC indicators or gages are inoperative, refer to Instrument Cluster Gages Inoperative .
  2. Ignition OFF, disconnect the ECM harness connectors. Ignition ON, the MIL should not illuminate.
    • If the MIL is illuminated, test the MIL control circuit for a short to ground. If the circuit tests normal, replace the IPC.
  3. Ignition ON, connect a 3A fused jumper wire between the MIL control circuit and ground. The MIL should illuminate.
    • If the MIL does not illuminate, test the MIL control circuit for a short to voltage, or an open/high resistance. If the circuit test normal, replace the IPC/bulb.
  4. If all circuits/connections test normal, replace the ECM.
scientia non olet · About Mike's Workshop Manuals