Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Cadillac >> 2008 >> SRX 3.6 7, AWD >> Repair and Diagnosis >> Electrical >> Charging Systems >> Battery, Charging System And Starting System >> Repair Instructions >> Battery Current Sensor Replacement >> Removal Procedure

Removal Procedure

    Fig 1: View Of Battery Current Sensor
    GM1475086Courtesy of GENERAL MOTORS CORP.
  1. Remove the negative battery cable. Refer to Battery Negative Cable Replacement (LH2 (LHD))  or Battery Negative Cable Replacement (LH2 (RHD))  or Battery Negative Cable Replacement (LY7 (LHD))  or Battery Negative Cable Replacement (LY7 (RHD)) .
  2. Cut the tie straps and electrical tape attaching the battery current sensor to the battery cable.
  3. Squeeze the negative battery cable branches together.
    4. IMPORTANT: Note the position of the battery current sensor prior to removal.
  4. Slide the battery current sensor (1) off of the negative battery cable.
scientia non olet · About Mike's Workshop Manuals