Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Cadillac >> 2008 >> Escalade EXT >> Repair and Diagnosis >> Body & Frame >> Ignition Switch/Steering Lock >> Wiring Systems And Power Management - Introduction >> Repair Instructions >> Ignition and Start Switch Replacement >> Removal Procedure

Removal Procedure

    CAUTION: Refer to SIR Caution .
  1. Remove the knee bolster. Refer to Knee Bolster Replacement (Except Cadillac) or Knee Bolster Replacement (Cadillac) .
  2. Remove the theft deterrent module. Refer to Theft Deterrent Module Replacement .
  3. Disconnect the passlock and key buzzer from the ignition lock cylinder case.
    4. Fig 1: Inserting J 42759 Into Lock Cylinder Housing
    GM1413831Courtesy of GENERAL MOTORS CORP.
  4. Insert release tool J-42759  into the ignition lock cylinder case to release the tabs on the ignition/start switch. See Special Tools .
  5. Pull the ignition/start switch out of the ignition lock cylinder case.
  6. Disconnect the electrical connector from the ignition/start switch.
scientia non olet · About Mike's Workshop Manuals