Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Cadillac >> 2008 >> CTS 3.6 7, AWD >> Repair and Diagnosis >> Brakes >> Anti-Lock Brake System, Traction Control System & Stability Control System >> Diagnostic Information and Procedures >> DTC C0292 >> Circuit/System Testing

Circuit/System Testing

  1. Ignition OFF, disconnect the yaw rate and lateral acceleration sensor connector.
  2. Ignition OFF, test for less than 1 ohm of resistance between the low reference circuit terminal 6 and ground.
    • If greater than 1 ohm, test the low reference circuit terminal 6 and the EBCM ground circuit terminal 25 for an open/high resistance. If the circuits test normal, replace the EBCM.
  3. Test the lateral accelerometer 12-volt reference circuit terminal 1, for an open/high resistance or a short to voltage or ground.
    • If all circuits test normal, replace the yaw rate sensor/lateral acceleration sensor, and clear the yaw rate sensor offset value in the EBCM.
    • If the DTC sets again after replacing the yaw rate sensor/lateral acceleration sensor, replace the EBCM.
scientia non olet · About Mike's Workshop Manuals