Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Cadillac >> 2008 >> CTS 3.6 7, AWD >> Repair and Diagnosis >> Accessories & Equipment >> Collision/Avoidance >> Object Detection System >> Diagnostic Information and Procedures >> DTC B1E3A >> Circuit/System Testing

Circuit/System Testing

  1. Verify that DTC B1325 is not set.
  2. Verify that DTC B0958, B0959, B0960 or B0961 is not set.
  3. Ignition ON and with the transmission range in REVERSE, verify that the scan tool Sensor Feed Voltage Output parameter is between 7.2 V - 9.2 V.
    • If less than the specified range, test the supply voltage circuit terminal 4 for a short to ground or an open/high resistance. If the circuit tests normal, replace the rear object alarm module.
    • If greater than the specified range, test the supply voltage circuit terminal 4 for a short to voltage. If the circuits test normal, replace the object alarm module.
  4. If all circuits test normal, replace the suspect object alarm sensor.
scientia non olet · About Mike's Workshop Manuals