Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Cadillac >> 2007 >> XLR Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 45 (Power Seat System) >> Repair Instructions >> Rear Seat Control Module Replacement - Rear Seat Number 2 >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2008 Cadillac SRX. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the seat control module on to seat adjuster.
    2. Fig 1: View Of Seat Control Module Electrical Connector & Retaining Nuts
    GM1261005Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice .
  2. Install the seat control module nuts (2).

    Tighten:  Tighten the nuts to 9 N.m (80 lb in).

  3. Connect the electrical connector (2) to the control module.
  4. Install the seat cushion frame. Refer to Rear Seat Number 2 Cushion Frame Replacement .
  5. Calibrate the seat. Refer to Power Folding Seat Calibration .
scientia non olet · About Mike's Workshop Manuals