Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Cadillac >> 2007 >> XLR Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 29 (Engine Control System & Fuel System - 4.6L (LH2) - Introduction) >> Repair Instructions >> Manifold Absolute Pressure Sensor Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2008 Cadillac SRX. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of MAP Sensor
    GM1234885Courtesy of GENERAL MOTORS CORP.
  1. Install the MAP sensor (3).
    2. NOTE: Refer to Fastener Notice .
  2. Install the bracket (2) and bolt (1).

    Tighten:  Tighten the bracket bolt to 12 N.m (106 lb in).

    3. Fig 2: View Of MAP Sensor Electrical Connector
    GM1234884Courtesy of GENERAL MOTORS CORP.
  3. Connect the MAP sensor electrical connector.
  4. Install the fuel injector sight shield. Refer to Fuel Injector Sight Shield Replacement .
scientia non olet · About Mike's Workshop Manuals