Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Cadillac >> 2007 >> XLR Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 29 (Engine Control System & Fuel System - 4.6L (LH2) - Introduction) >> Repair Instructions >> Fuel Tank Pressure Sensor Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2008 Cadillac SRX. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Fuel Tank Pressure Sensor Electrical Connector
    GM802790Courtesy of GENERAL MOTORS CORP.
  1. Press the fuel tank pressure sensor into the fuel tank, until the locking tabs are fully seated.
  2. Close the retaining strap.
  3. Connect the electrical connector to the fuel tank pressure sensor.
  4. Install the fuel tank. Refer to Fuel Tank Replacement .
scientia non olet · About Mike's Workshop Manuals