Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Cadillac >> 2007 >> XLR Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 13 (Cellular System, Entertainment System, And Navigation System) >> Repair Instructions >> Digital Radio Antenna Cable Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2008 Cadillac SRX. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the right rear body side trim. Refer to Body Side Rear Trim Panel Replacement (w/TB5) or Body Side Rear Trim Panel Replacement (w/o TB5) .
  2. Remove the right rear body side garnish molding. Refer to Body Side Rear Upper Garnish Molding Replacement (w/TB5) or Body Side Rear Upper Garnish Molding Replacement (w/o TB5) .
  3. Remove the headliner. Refer to Headlining Trim Panel Replacement .
    4. Fig 1: View Of Digital Radio Receiver Electrical Connectors
    GM1211148Courtesy of GENERAL MOTORS CORP.
  4. Disconnect the digital antenna connector from the receiver.
    5. Fig 2: View Of Digital Antenna Cable
    GM1211078Courtesy of GENERAL MOTORS CORP.
  5. Disconnect the digital antenna cable connector from the antenna.
  6. Remove the cable.
scientia non olet · About Mike's Workshop Manuals