Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Cadillac >> 2007 >> XLR Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 11 (Supplemental Inflatable Restraint System) >> Repair Instructions >> Inflatable Restraint Steering Wheel Module Coil Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2008 Cadillac SRX. However, it is still accessible from the selected car via links, so may be relevant.
    CAUTION: Refer to SIR Caution .
  1. Disable the supplemental inflatable restraint (SIR) system. Refer to SIR Disabling and Enabling .
  2. Remove the knee bolster. Refer to Knee Bolster Replacement (Left Hand Drive) or Knee Bolster Replacement (Right Hand Drive) .
  3. Remove the steering column trim covers. Refer to Steering Column Trim Covers Replacement .
  4. Disconnect the inflatable restraint steering wheel module coil electrical connectors and disconnect the inflatable restraint steering wheel module coil electrical harness from the steering column wiring harness.
    5. Fig 1: Steering Column Upper Shaft Retaining Ring
    GM360597Courtesy of GENERAL MOTORS CORP.
  5. Remove the inflatable restraint steering wheel module coil retaining ring (1) from the upper steering shaft (2).
  6. Remove the inflatable restraint steering wheel module coil from the steering column.
    7. Fig 2: Identifying Steering Wheel Module Coil Washer
    GM361725Courtesy of GENERAL MOTORS CORP.
  7. Remove the inflatable restraint steering wheel module coil washer (1) if necessary.
scientia non olet · About Mike's Workshop Manuals