Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Cadillac >> 2007 >> XLR Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 11 (Supplemental Inflatable Restraint System) >> Repair Instructions >> Inflatable Restraint Sensing and Diagnostic Module Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2008 Cadillac SRX. However, it is still accessible from the selected car via links, so may be relevant.
    CAUTION: Do not strike or jolt the inflatable restraint sensing and diagnostic module (SDM). Before applying power to the SDM, make sure that it is securely fastened with the arrow facing toward the front of the vehicle. Failure to observe the correct installation procedure could cause SIR deployment, personal injury, or unnecessary SIR system repairs.
    CAUTION: Refer to SIR Caution .
  1. Disable the SIR system. Refer to SIR Disabling and Enabling .
  2. Remove the center console. Refer to Front Floor Console Replacement (Left Hand Drive) or Front Floor Console Replacement (Right Hand Drive) .
    3. Fig 1: View Of Connector Position Assurance (CPA) Flex Lock Button
    GM466123Courtesy of GENERAL MOTORS CORP.
  3. Remove the connector position assurance (CPA) (1) from the wiring harness connector (2) to the inflatable restraint sensing and diagnostic module (SDM).
  4. Push the flex lock button (3) down and move the sliding connector locking cover (4) to the OPEN position.
    5. IMPORTANT: The SDM is shown with the carpet removed for illustration purposes only. Removal of the front carpet or the front seats is not necessary to service the SDM.
    Fig 2: View Of SDM & Mounting Fasteners
    GM751942Courtesy of GENERAL MOTORS CORP.
  5. Disconnect the wiring harness connector from the SDM (1).
  6. Remove the SDM mounting fasteners (2).
  7. Remove the SDM from the console floor.
scientia non olet · About Mike's Workshop Manuals