Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Cadillac >> 2007 >> XLR Base >> Repair and Diagnosis >> Body & Frame >> Ignition Switch/Steering Lock >> Wiring Systems And Power Management - Introduction >> Repair Instructions >> Ignition and Start Switch Replacement >> Removal Procedure

Removal Procedure

    CAUTION: Refer to BATTERY DISCONNECT CAUTION .
  1. Disconnect the negative battery cable.
  2. Remove the driver knee bolster trim panel. Refer to Driver Knee Bolster Panel Replacement .
  3. Remove the driver information center (DIC) switch. Refer to Driver Information Display Switch Replacement .
    4. Fig 1: View Of Ignition Switch & Electrical Connector
    GM1224598Courtesy of GENERAL MOTORS CORP.
  4. Disconnect the ignition switch electrical connector.
  5. Remove the ignition switch from the DIC pod.

    Carefully pull to unsnap.

scientia non olet · About Mike's Workshop Manuals