Installation Procedure
WARNING: This page is about a different car, the 2010 Cadillac STS. However, it is still accessible from the selected car via links, so may be relevant.
- Locate the instrument panel retainer to the carrier.
- Route the instrument panel wire harness in to the previous noted location.
- Install the screws securing the passenger side of the instrument panel retainer and tighten to 9 N.m (18 lb in).
- Install the screws securing the instrument panel to the carrier and tighten to 9 N.m (18 lb in).
- Install the instrument panel storage compartment. Refer to Instrument Panel Compartment Replacement .
- Install the instrument cluster. Refer to Instrument Cluster Replacement .
- Install the knee bolster bracket. Refer to Driver Knee Bolster Reinforcement Replacement .
- Install the left and right instrument panel insulator panels. Refer to Instrument Panel Insulator Panel Replacement - Right Side and Instrument Panel Insulator Panel Replacement - Left Side .
- Install the HVAC control module. Refer to HVAC Control Module Replacement .
- Install the ashtray/storage bin. Refer to Ashtray Replacement .
- Install the radio. Refer to Radio Replacement .
- Install the instrument center trim. Refer to Instrument Panel Center Trim Panel Replacement .
- Install the defroster grille. Refer to Defroster Grille Replacement .
- Install the center floor console. Refer to Front Floor Console Replacement .
- Install the front seats. Refer to Bucket Seat Replacement .
- Install the steering wheel. Refer to Steering Wheel Replacement
CAUTION:
Refer to Fastener Caution
.