Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Cadillac >> 2007 >> SRX 4.6 A, AWD >> Repair and Diagnosis >> Engine Performance >> System >> Engine Control System & Fuel System - 4.6L - DTC P0010 To DTC P0336 >> DTC P0102 or P0103 >> Circuit/System Testing

Circuit/System Testing

  1. Ignition OFF, disconnect the harness connector at the MAF/IAT sensor.
  2. Ignition OFF, allow sufficient time for the ECM to power down. Test for less than 5 ohms of resistance between the MAF low reference circuit terminal D and ground.
    • If greater than the specified range, test the low reference circuit for an open/high resistance. If the circuit tests normal, replace the ECM.
  3. Ignition ON, test for 4.8-5.2 volts between the MAF signal circuit terminal A and ground.
    • If less than the specified range, test the signal circuit for a short to ground or an open/high resistance. If the circuit tests normal, replace the ECM.
    • If greater than the specified range, test the signal circuit for a short to voltage. If the circuit tests normal, replace the ECM.
  4. Ignition ON, verify a test lamp illuminates between the ignition circuit 1 terminal C and ground.
    • If the test lamp does not illuminate, test the ignition circuit for a short to ground or an open/high resistance.
  5. Connect the J 38522  to the vehicle. Refer to Component Testing.
scientia non olet · About Mike's Workshop Manuals