Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Cadillac >> 2007 >> SRX 4.6 A, AWD >> Repair and Diagnosis >> Engine Performance >> System >> Engine Control System & Fuel System - 4.6L - Introduction (2 Of 2) >> Repair Instructions >> Throttle Body Assembly Replacement >> Installation Procedure

Installation Procedure

NOTE: Do not use a cleaner which contains methyl ethyl ketone. This extremely strong solvent may damage components and is not necessary for this type of cleaning.Use a carburetor cleaner in order to remove deposits.Refer to the instructions provided with the cleaner.
IMPORTANT: Do not reuse the old throttle body gasket.
  1. Install the NEW gasket to the throttle body assembly.
    Fig 1: View Of Throttle Body Assembly
    GM927998Courtesy of GENERAL MOTORS CORP.
  2. Install the throttle body assembly to the water housing.
    NOTE: Refer to Fastener Notice in the Preface section.
  3. Install the throttle body assembly mounting bolts.

    Tighten:  Tighten the bolts to 10 N.m (89 lb in).

  4. Connect the electrical connector to the throttle body assembly.
    Fig 2: View Of Throttle Body Assembly Electrical Connector
    GM887927Courtesy of GENERAL MOTORS CORP.
  5. Install the air cleaner outlet duct. Refer to Air Cleaner Outlet Duct Replacement .
  6. Install the fuel injector sight shield. Refer to Fuel Injector Sight Shield Replacement .
  7. Perform the Throttle Body Learn procedure. Refer to Throttle Learn .
scientia non olet · About Mike's Workshop Manuals