Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Cadillac >> 2007 >> SRX 4.6 A, AWD >> Repair and Diagnosis >> Engine Performance >> System >> Engine Control System & Fuel System - 4.6L - Introduction (2 Of 2) >> Repair Instructions >> Primary Fuel Level Sensor Replacement >> Installation Procedure

Installation Procedure

  1. Complete the following in order to install the fuel level sensor (1) to the module assembly:
    1. Align the tabs of the sensor (1) with the slots in the module assembly.
    2. Slide the sensor (1) fully into position, ensure the locking tab (2) is engaged.
    Fig 1: View Of Fuel Level Sensor & Locking Tab
    GM820629Courtesy of GENERAL MOTORS CORP.
  2. Connect the fuel level sensor electrical connector (1) to the module.
    Fig 2: View Of Primary Fuel Level Sensor Electrical Connector
    GM820628Courtesy of GENERAL MOTORS CORP.
  3. Install the primary fuel tank module. Refer to Primary Fuel Tank Module Replacement .
scientia non olet · About Mike's Workshop Manuals