Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Cadillac >> 2007 >> SRX 4.6 A, AWD >> Repair and Diagnosis >> Engine Performance >> System >> Engine Control System & Fuel System - 4.6L - Introduction (2 Of 2) >> Repair Instructions >> Manifold Absolute Pressure Sensor Replacement >> Removal Procedure

Removal Procedure

  1. Turn the ignition OFF.
    Fig 1: View Of MAP Sensor Electrical Connector
    GM1234884Courtesy of GENERAL MOTORS CORP.
  2. Remove the fuel injector sight shield. Refer to Fuel Injector Sight Shield Replacement .
  3. Disconnect the manifold absolute pressure (MAP) sensor electrical connector.
  4. Remove the bolt (1) and bracket (2) from the MAP sensor (3).
  5. Remove the MAP sensor (3).
    Fig 2: View Of MAP Sensor
    GM1234885Courtesy of GENERAL MOTORS CORP.
  6. Inspect the MAP sensor seal for wear or damage. If a problem is found, replace as necessary.
scientia non olet · About Mike's Workshop Manuals