Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Cadillac >> 2007 >> SRX 4.6 A, AWD >> Repair and Diagnosis >> Engine Performance >> System >> Engine Control System & Fuel System - 4.6L - Introduction (2 Of 2) >> Repair Instructions >> Manifold Absolute Pressure Sensor Replacement >> Installation Procedure

Installation Procedure

  1. Install the MAP sensor (3).
    Fig 1: View Of MAP Sensor
    GM1234885Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice .
  2. Install the bracket (2) and bolt (1).

    Tighten:  Tighten the bracket bolt to 12 N.m (106 lb in).

  3. Connect the MAP sensor electrical connector.
    Fig 2: View Of MAP Sensor Electrical Connector
    GM1234884Courtesy of GENERAL MOTORS CORP.
  4. Install the fuel injector sight shield. Refer to Fuel Injector Sight Shield Replacement .
scientia non olet · About Mike's Workshop Manuals