Removal Procedure
- Disable the SIR System. Refer to SIR Disabling and Enabling .
- Verify the following before removing the SIR coil:
- The wheels on the vehicle are straight ahead.
- That J 42640 is installed or the ignition switch is in the LOCK position. See Special Tools .
- Remove the steering wheel from the steering shaft. Refer to Steering Wheel Replacement .
- Remove the steering column trim covers. Refer to Steering Column Trim Covers Replacement .
- Remove the wire harness straps from the steering wheel column wire harness.
- Remove the retaining ring (3).
- Remove the SIR coil (4) from the steering shaft.
- If replacing, discard the SIR coil.
CAUTION:
Refer to SIR Caution
.
NOTE:
The wheels of the vehicle must be straight ahead and the steering column in the LOCK position before disconnecting the steering column or intermediate shaft from the steering gear. Failure to do so will cause the SIR coil assembly to become uncentered, which may cause damage to the coil assembly.