Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Cadillac >> 2007 >> Escalade EXT >> Repair and Diagnosis >> External Pages >> Different car >> Section 721 (HVAC Systems - Automatic) >> Repair Instructions >> Inside Air Temperature Sensor Assembly Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2006 GMC Sierra, 2006 GMC Cab & Chassis Sierra, 2006 Chevrolet Silverado, and 2006 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the left windshield garnish molding. Refer to Garnish Molding Replacement - Windshield Pillar in Interior Trim.
  2. Remove the left center pillar assist handle. Refer to Assist Handle Replacement - Rear in Interior Trim.
  3. Remove the left center pillar garnish molding. Refer to Garnish Molding Replacement - Center Pillar in Interior Trim.
  4. Remove the left sunshade. Refer to Sunshade Replacement in Interior Trim.
  5. Gently pull down the headliner.
  6. Disconnect the electrical connector from the inside air temperature sensor.
    Fig 1: Disconnecting Inside Air Temperature Sensor Connector
    GM675996Courtesy of GENERAL MOTORS CORP.
  7. Partially remove the inside air temperature sensor from the headliner.
  8. Remove the sensor grille from the inside air temperature sensor.
  9. Remove the inside air temperature sensor from the headliner.
    Fig 2: Inside Air Temperature Sensor
    GM675994Courtesy of GENERAL MOTORS CORP.
scientia non olet · About Mike's Workshop Manuals