Installation Procedure

WARNING: This page is about a different car, the 2006 GMC Sierra and 2006 Chevrolet Silverado. However, it is still accessible from the selected car via links, so may be relevant.

Install the brackets to the vehicle and hand tighten the nuts.

Fig 1: Installing Tool Storage Compartment Brackets (PRO)
Courtesy of GENERAL MOTORS CORP.
Install the tool storage compartment. Refer to Tool Storage Compartment Replacement (PRO) .

NOTE: Refer to Fastener Notice .

Tighten the nuts that retain the tool storage compartment brackets (1), (2) to the seat riser studs.
Tighten: Tighten the nuts to 50 N.m (36 lb ft).
Install the rear seat hinge filler panel cover and plastic push pins.